Electrical Disclaimer Further Information
Hi,
I'm the original owner of this Woo Audio WA22 Class A push pull fully balanced headphone amp. This is a Gen1 version which doesn't have the preamplifier output on the back, but is more powerful. Give me more power over a pre any day. This will run pretty much any set of headphones. It has driven my Audeze and Hifiman headphones superbly, albeit they're incredibly different animals. It's from Woo so you know it's quality, built in the USA (11 kgs!). This comes with two full sets of tubes - the stock ones that came with the unit and also the ones I've upgraded to (N.O.S. and direct from Woo Audio). I purchased the amp about 10 years ago. Usage for the first two years was about once or twice per week mainly on the stock tubes. Over the past 8 years you'd be lucky if it's been turned on a dozen times - that's why I'm selling it. This is not my main listening gear, I have a stereo set-up so it's been sitting on the desk as a paper weight for a long time. The 596 wouldn't have 10 hours on it. The 5998's and 6SN7GT less than 100 hours. Stock tubes a few hundred hours. This presents in excellent condition and works perfectly.
The stock tubes are included in the sale, no I will not separate. The following upgraded tubes were bought NOS directly from Woo Audio -
2x Sylvania 6SN7GT;
2x 5998 Tung Sol (USA made);
1x 596 USAF (with Woo manufactured adaptor).
Upgraded tubes cost me $USD1,300 alone! Considering the price of tubes and postage these days, this presents as a great buy. I have the original boxing so can post AUS wide and shipping is included in the sale price. Upgraded tubes would (likely) have to be posted separately, but again at my expense.
Cash on pick-up or EFT only. This is the lowest price that I'll accept, and considering the upgraded tubes are included along with a full set of stocks as back-up, this is incredible value.
Details -
Power output: 810 mw with 6080, 2 watts with 7236 power tubes
Frequency response: 8 Hz – 50 KHz, -3dB
Ideal headphone impedance: 8-600 Ohms
Amplifier Input impedance: 100k Ohms
Analog Inputs: One single-ended stereo pair (via RCA jack), one balanced stereo pair (via 3-pin XLR jacks), with single-ended/balanced input selector switch
Analog Outputs: three balanced headphone outputs (one stereo output via 1/4″ phone jack, one stereo output via a single 4-pin XLR jack, one via a separate left/right pair of 3-pin XLR jacks), hi/lo gain selector switch
Signal/Noise ratio: 92 dB
Distortion (THD): <= 0.3%
Dimensions (H x W x D): 7” x 12” x 10.5”
Weight: 25 pounds
English (US)